Home          Sail          Power         Human Power         Fun         Tools         Energy         About /Contact

 

Copyright 2001-2016 inclusive   McGowan Marine Design, Inc.

Hot Hot Hot!

a cool water taxi for combatting global warming

Hot Hot Hot! came about when I was asked to come up with a design for a solar/electric water taxi for a small Caribbean island.  The requirements were for a boat, or fleet of boats that could take 5-8 people from a dock then land them on a beach, or take them out diving over a reef.  It had to have solar panels for low operating costs and a zero carbon footprint.  It also had to be robust, and a bit funky (colourful) as that’s what the present outboard-powered ones are.


The hull design is based on a 65’ catamaran that was tank tested very well, and showed to be especially good in speed ranges below a S/L ratio of 1.5.  (that is, up to 1.5 x the theoretical hullspeed, or pre-planing range).

( Windows version here )

Hot Hot Hot!  Quicktime Movie

Construction is stitch-and-glue plywood with fibreglass sheathing for toughness.  The narrow flat bottom is good for beaching, and the upper hull shape has a nice chine flat, with the lower ‘canoe’ hull for battery storage and drive motor/shaft setup.  The shaft is horizontal and with a dripless seal, and the prop is shrouded by a Kitchen Rudder - providing greater control, and diver protection.


There are three ‘levers’ for operating the boat: a joggle stick for steering (beside the helm), a rudder actuator (for opening and closing the Kitchen Rudder - located in front of the helmsman), and the throttle (a simple rheostat lever as only ‘on’ and ‘forward’ are needed with the Kitchen Rudder).  Rather than using a threaded rod-controlled actuator at the rudder post head - as in the typical Kitchen Rudder - for simplicity and greater control I’ve opted for a straight levered linkage, with hydraulics between the top of the rudder post and the shifter at the helm.  Like changing gears in a car - the shifter at the helm would have slots at predetermined places for different settings at the rudder: fully open, partially closed for crabbing side-ways (maybe two settings) and fully closed. 

At first, I looked at electric outboards but couldn’t find any that could handle full-time work in salt water.  Then I remembered the interesting asymmetric catamarans (proas, really) that Aspen Power Catamarans makes, and gladly adopted a single-drive system - but without the proa hull setup as the speeds needed to be less than 6 knots: that is, never needing to plane.  As anyone who’s moved a catamaran around with a single outboard at slower speeds knows, you really don’t notice if the motor is off-centre.  The true catamaran hull configuration simplifies construction and maximizes load-carrying ability and flexibility.

LOA

Beam

Draft

1/2 Load Displacement

Motor Size

Panels

Wind Generator

18’1”

8’-5”

1’-3”

2000 lbs

6-9 kW 48v

4 x 245W

400 W

5.51

2.57m

0.38m

0.91t

Specifications

Solar charging in the tropics is an easy choice, and the small wind generator would allow for charging day or night - as long as the wind is blowing: perfect for overnight charging after a long day of motoring. 


This could make a an amazing little cruiser!  Imagine glass all-around, a Queen-sized folding couch aft, full headroom in hulls: with head to starboard (aft), galley to port (fwd), a bench seat helm and controls in the centre (with sitting headroom), and a sliding door in the centre of each side.  Access forward through a large opening window, with windscreens tilting forward - trawler-style.  Very cool, efficient, and fast!

Designed with TouchCad